Querx PT’s Sensor Cable Connector Has Changed

Up until now, the Querx PT models’ (Querx PT100, Querx PT1000, Querx WLAN PT100, Querx WLAN PT1000) pair of two-wire connectors, into which the 2-, 3- or 4-wire sensor cables are clamped, were stacked vertically.

Querx PT - Version 1.0
Querx PT - Version 1.0

From version 1.1 on, the four screw-terminals are placed side by side so the individual wire ends can be easily secured with a flat-tip screwdriver.

Querx PT - Version 1.1

The DIP switch that is used to set how many wires are used to connect the sensor to Querx PT has been rotated by 90 degrees.

DIP Switch Positions

Leave a Reply

Your email address will not be published. Required fields are marked *